Image is for illustration only and should not be relied upon Sunvic TLX1012 Wireless Digital Thermostat

Sunvic TLX1012 Wireless Digital Thermostat

0 reviews

£29.99

Ex VAT: £24.99

10 or more £27.59 (Ex VAT: £22.99) each

Brand: Sunvic (Satchwell)

HCO Code: 16C02

Availability: In Stock

The wireless (RF) TLX 1012 is the latest addition to the popular TLX 1000 series of electronic room thermostats. The thermostat has been designed to be easy to operate and quick to install and benefits from energy saving Time Proportional and Integral control, reducing energy usage by up to 10% and increasing user comfort

Quick & easy to install - save time and money
TPI Control - reduce your customer's energy bills by up to 10%
Simple to use - fewer installer call backs
Large backlit LCD - easy to read for people with poor eyesight
Volt-free switching - suitable for use with most combination boilers
Surface mount receiver - no need to channel walls
Direct replacement for TLX1010

Write a review

Your Name

Your Review

Note: HTML is not translated!

Rating Bad Good

Captcha

Please complete the captcha validation below

Expand All

I have looked at the wiring diagram for the received and it shows only two wires a live (brown) and a neutral (blue). My old receiver also has a black wire connected to it. Where should this be connected to with the TLX1012 receiver as it isn't shown on the wiring diagram? Answers1

There are 5 terminals on the receiver that are normally wired as follows:
N - Neutral
L - Live
ON - Output to motorised valve or boiler
COM - Switched live from programmer
OFF - Not normally used

I want to replace an old Honeywell wired wall stat with this Sunvic TXL1012 wireless model, connected to the Drayton LP241 controller of my Wallstar oil boiler. Will the TPI energy-saving feature of the new stat work as designed? Answers1

It does require a permanent live, so you will need to either add one, or install the receiver next to the programmer instead.

We have a TLX 7506 which has stopped working what can replace it? We have the TLX 1206 receiver.
Thanks Answers1

Nothing will connect to the existing receiver.

This will replace it, but you will need to replace the receiver with the one included.

hello - my TLX7506 wireless thermostat and 1206 receiver are becoming a little unreliable. As I'm not an electrician, I'm cautious about a DIY replacement - but noted your advice that replacing the 1206 with this receiver unit is just using the same 4 wires. If it's an obvious like-for-like swap then perhaps I should take it on!. Can you confirm it really is this simple?? thanks... Answers1

It is fairly simple. Live, Neutral and two control wires. If you can change a plug, then you should be OK.

Piease what is the operating distance for the TLX1012 Wireless Thermostat

thank you. Answers1

It is 30m in open air. Walls and ceilings will lower this depending on construction.

I have a TLX-1010 room stat and receiver. Will the new TLX1012 link up to the existing TLX-1010 receiver? Answers1

Yes it will.

is this compatible with a main eco elite combi Answers1

Yes it is.

Is this suitable for a Remeha Advanta Combi Answers1

Yes it is.

is it compatible with Main Eco Compact Combi Answers1

Yes it is.

Will it replace my sunvic digital thermostat which has 2 wires and switches mains voltage to boiler? (old gloworm spacesaver) Answers1

As the receiver is mains powered, you will need to place the receiver near the boiler or airing cupboard. The 2 wires to the existing wired thermostat are not enough.